Check for continuity between body ground and the PGM-FI main relay 14P connector terminals No. 2 and No. 4 individually. Wire side of female terminals Is there continuity? YES - Repair short in the wire between the No. 6 ECU (ECM/PCM) (15A) fuse and the PGM-FI main relay 1. Also replace the No. 6 ECU (ECM/PCM) (15A) fuse. NO - Go to step 22. Disconnect each of the components or the connectors below, one at a time, and check for continuity between the PGM-FI main relay 1 4P connector terminal No. 1 and body ground. PGM-FI main relay 2 ECM/PCM connector A (31P) Each injector 2P connector Idle air control (IAC) valve 3P connector Top dead centre (TDC) sensor 3P connector Crankshaft position (CKP) sensor 3P connector Wire side of female terminals

Is there continuity? YES - Go to step 23. NO - Replace the component that made continuity to body ground go away when disconnected. If the item is the ECM/PCM, substitute a known-good ECM/PCM and recheck (see page 11-6). If symptom/indication goes away, replace the original ECM/PCM. Also replace the No. 6 ECU (ECM/PCM) (15 A) fuse. Disconnect the connectors of all these components. PGM-FI main relay 2 ECM/PCM connector A (31P) Injectors Idle air control (IAC) valve Top dead centre (TDC) sensor Crankshaft position (CKP) sensor Check for continuity between the PGM-FI main relay 1 4P connector terminal No. 2 and body ground. Wire side of female terminals Is there continuity? YES - Repair short in the wire between the PGM-FI main relay 1 and each item. Also replace the No. 6 ECU (ECM/PCM) (15A) fuse. NO - Replace the PGM-FI main relay 1. Also replace the No 6 ECU (ECM/PCM) (15A) fuse.