DTC 65:Secondary HO2S (Sensor 2) Heater Circuit Malfunction NOTE: Information marked with an asterisk (*) applies to D15Y4, D17A2 (KU, KQ, KZ, FO models), D17Z1 (KQ model) engines. Reset the ECM/PCM (see page 11-167). Start the engine. Is the MIL on and does it indicate DTC 65? YES - Go to step 3. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose wires at Secondary HO2S (Sensor 2) and at the ECM/PCM. Turn the ignition switch OFF. Disconnect the secondary HO2S (Sensor 2) 4P connector. At the HO2S side, measure resistance between the secondary HO2S 4P connector terminals No. 3 and No. 4. SECONDARY HO2S (SENSOR 2) 4P CONNECTOR Wire side of female terminals Is there 10-40 ohms? YES - Go to step 6. NO - Replace the secondary HO2S (Sensor 2).

Check for continuity between body ground and the secondary HO2S 4P connector terminals No. 3 and No. 4 individually. SECONDARY HO2S (SENSOR 2) 4P CONNECTOR Wire side of female terminals Is there continuity? YES - Replace the Secondary HO2S (Sensor 2). NO - Go to step 7. Turn the ignition switch ON (II). Measure voltage between the secondary HO2S 4P connector terminals No. 3 and No. 4. SECONDARY HO2S (SENSOR 2) 4P CONNECTOR Terminal side of male terminals Is there battery voltage? YES - Go to step 9. NO - Go to step 12. Turn the ignition switch OFF. Disconnect ECM/PCM connector A (31P) (ECM/PCM connector E (31P))*.