DTC P0141: Secondary HO2S (Sensor 2) Heater Circuit Malfunction Reset the ECM/PCM (see page 11-4). Start the engine. Is DTC P0141 indicated? YES - Go to step 3. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose wires at the secondary HO2S (Sensor 2) and at the ECM/PCM. Turn the ignition switch OFF. Disconnect the secondary HO2S (Sensor 2) 4P connector. At the secondary HO2S (Sensor 2) side, measure resistance between the HO2S 4P connector terminals No. 3 and No. 4. SECONDARY HO2S (SENSOR 2) 4P CONNECTOR Wire side of female terminals Is there 10-40 ohms? YES - Go to step 6. NO - Replace the secondary HO2S (Sensor 2).

Check continuity between body ground and the secondary HO2S (Sensor 2) 4P connector terminals No. 3 and No. 4 individually. SECONDARY HO2S (SENSOR 2) 4P CONNECTOR Wire side of female terminals Is there continuity? YES - Replace the secondary HO2S (Sensor 2). NO - Go to step 7. Turn the ignition switch ON (II). Measure voltage between the secondary HO2S 4P connector terminals No. 3 and No. 4. SECONDARY HO2S (SENSOR 2) 4P CONNECTOR Terminal side of male terminals Is there battery voltage? YES - Go to step 9. NO - Go to step 12. Turn the ignition switch OFF. Disconnect ECM/PCM connector E (31P).