Special Tools Required Snap ring pliers, 07LGC-0010100 Handle driver, 07949-3710001 Handle driver, 07749-0010000 Driver attachment, 62 x 68 mm, 07746-0010500 Driver attachment, 72 x 75 mm, 07746-0010600 NOTE: Coat all parts with ATF before assembly. To remove the mainshaft bearing (A), countershaft bearing (B) and sub-shaft bearing (C) from the transmission housing, expand each snap ring with the snap ring pliers, then push the bearing out. NOTE: Do not remove the snap ring unless it's necessary to clean the grooves in the housing.

Install the bearings in the direction shown. Expand each snap ring with the snap ring pliers and install the bearing part-way into the housing. Release the pliers, then push the bearing down into the housing until the snap ring snaps in place around it. After installing the bearings verify that the snap rings (A) are seated in the bearing and housing grooves and that the ring end gaps (B) are correct.