Special Tools Required Threaded adapter, 22 x 1.5 mm, 07XAC-0010100 Slide hammer, 07936-5790001 Boot band pincer, commercially available Inboard Joint Side: Remove the set ring (A) from the inboard joint. Remove the boot bands. Take care not to damage the boot and dynamic damper. If the boot band is welded type (A), cut the boot band (B). If the boot band is a double loop type (C), lift up the band bend (D) and push it into the clip (E). If the boot band is a low profile type (F), pinch the boot band using the commercially available boot band pincer (G). If the boot band is an ear clamp type (H), lift up the three tabs (I) with a screwdriver. Welded Type

Double Loop Type Low Profile Type Ear Clamp Type