Turn the ignition switch ON (II). Measure the voltage between the appropriate EPS control unit connector C (20P) terminal and body ground (see table). Terminal name EPS control unit connector C terminal No. Vcc1 3 Vcc2 11 VT3 13 VT6 1 (5)* T/S GND 2 EPS CONTROL UNIT CONNECTOR C (20P) Wire side of female terminals Is there battery voltage? YES - Repair short to power in the + circuit wire between the EPS control unit and torque sensor. NO - Go to step 9.

Turn the ignition switch OFF. Check for continuity between the appropriate EPS control unit connector C (20P) terminal and the torque sensor terminal (see table). Terminal name Torque Sensor Terminal No. EPS control unit connector C terminal No. Vcc1 2 3 Vcc2 3 11 VT3 1 13 VT6 6 1 (5)* T/S GND 5 2 TORQUE SENSOR 6P CONNECTOR Wire side of female terminals Is there continuity? YES - Go to step 11. NO - Repair open in the appropriate torque sensor wire circuit between the EPS control unit and the torque sensor.