- Turn the front wheels to the straight ahead position.
- Check the toe. If it is not within the specification, go to step 3.
Front toe-in: 0 ± 3 mm (0 ± 0.12 in.)
- Loosen the locknut (A) while holding the tie-rod end (B).
- Turn the tie-rod (C) until the toe is correct.
NOTE: Adjust both the right and left wheels at the same time by the same amount in opposite directions to obtain the correct toe.
- After adjusting, tighten the locknut while holding the tie-rod end. Make sure the toe setting does not change.
- Release the parking brake.
- Check the toe. If it is not within the specification, go to step 3.
Rear toe-in: 2 ± 3mm (0.08 ± 0.12 in.)
- Loosen the self-locking nut (A) while holding the adjusting bolt (B).
Do not loosen the special bolts (C) on the lower arm to adjust the alignment.
- Replace the self-locking nut with a new one and lightly tighten it.
NOTE: Always use a new self-locking nut whenever you loosened it.
- Turn the adjusting bolt until the toe is correct.
Rear toe-in: 2+²-1 mm (0.08 +0.08-0.04 in.)
- Tighten the self-locknut to the specified torque while holding the adjusting bolt.
