ABS Components

ABS Modulator-Control Unit Removal and Installation

19-117  

NOTE:

Removal

  1. Pull up the lock (B) of the ABS control unit 25P connector (C), then disconnect the connector.

    1. FLARE NUT

      15 Nm (1.5 kgf/m, 11 lbf/ft)

    2. 6 mm BOLT

      9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)

    3. 6 mm BOLT

      9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)

  2. Disconnect the six brake lines.
  3. Remove the two 6 mm nuts.
  4. Remove the ABS modulator-control unit (A).

Installation

  1. Install the ABS modulator-control unit, then tighten the two 6 mm nuts.
  2. Align the connecting surface of the ABS control unit 25P connector.
  3. Push in the lock of the ABS control unit 25P connector until you hear it click into place, then connect the connector.
  4. Bleed the brake system, starting with the front wheels.
  5. Start the engine and check that the ABS indicator goes off.
  6. Test-drive the vehicle and check that the ABS indicator does not come on.