Glue the side rubber dams (A), lower rubber dam (B) and fasteners (C) to the inside face of the windshield (D) as shown: Be sure the rubber dam and fasteners line up with the alignment marks (E). Be careful not to touch the windshield where adhesive will be applied.

Glue the moulding (A) with adhesive tape (B) to the upper edge of the windshield (C): Be sure the alignment mark (D) of the moulding lines up with the alignment mark (E) of the windshield. Be careful not to touch the windshield where adhesive will be applied. Install the fasteners (A) and retainers (B, C) to the body. Fastener Locations A: Fastener, 2 B : Retainer, 2 C : Retainer, 6