Power Windows

Resetting the Power Window Control Unit - With Up-AUTO Function

22-199  

Resetting the power window control unit is required after performing the following procedures:

  1. Make sure the glass is installed properly.
  2. Close the driver's door.
  3. Turn the ignition switch OFF.
  4. Remove the No. 23 (20A) fuse in the under-dash fuse/relay box
  5. Turn the ignition switch ON (II).
  6. After 1 second, turn the ignition switch OFF.
  7. After 5 seconds, install the No. 23 (20A) fuse to the under-dash fuse/relay box.
  8. Make sure the driver's window does not work in AUTO with the ignition switch ON (II).
  9. Turn the ignition switch START (III) and start the engine.
  10. Move the driver's window all the way down by manual DOWN of the driver's power window switch.
  11. Open the driver's door.
  12. Move the driver's window all the way up by manual UP of the driver's power window switch and hold on for 1 second.
  13. If the window does not work in AUTO, reset the power window master switch according to the above procedures again.