Disconnect the U1o connector (A) from the SRS unit (B). Check resistance between the No. 5 and No. 14 terminals of the U1o connector. There should be 2.0 - 3.0 ohm. U1o CONNECTOR Wire side of female terminals Is the resistance as specified? YES - Faulty SRS unit or poor contact at the SRS unit connector; check the connection between the U1o connector and the SRS unit. If the connector is OK, replace the SRS unit (see page 23-176). NO - Open or increased resistance in dashboard wire harness B; replace dashboard wire harness B.

DTC 2-3: Short to Another Wire or Decreased Resistance in Front Passenger's Airbag Inflator Erase the DTC memory (see page 23-38). Turn the ignition switch ON (II), and check that the SRS indicator light comes on for about 6 seconds and then goes off. Does the SRS indicator light stay on? YES - Go to step 3. NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures (see page 23-38). Turn the ignition switch OFF. Disconnect the battery negative cable and wait for 3 minutes. Disconnect the P1o connector from the P1i connector (A). Connect the special tool (2 ohm) to the P1i connector. Reconnect the battery negative cable. Erase the DTC memory.