- Erase the DTC memory (see page 23-38).
- Turn the ignition switch ON (II), and check that the SRS indicator light comes on for about 6 seconds and then goes off.
Does the SRS indicator light stay on?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures (see page 23-38).
- Turn the ignition switch OFF. Disconnect the battery negative cable and wait for 3 minutes.
- Disconnect the TL1o connector from the TL1i connector (A).
- Connect the special tool (2 ohm) to the TL1i connector.
- Reconnect the battery negative cable.
- Erase the DTC memory.
- Read the DTC.
Is DTC 3-5 indicated?
YES - Go to step 9.
NO - Short to ground in the left side seat belt tensioner; replace the left side seat belt for 4-door model (see page 23-5) or 5-door model (see page 23-15). 
- Disconnect the battery negative cable and wait for 3 minutes.
- Disconnect the T2o connector (A) from the T2i connector (B).
4-door 5-door
- Connect the special tool (2 ohm) to the T2i connector.
- Reconnect the battery negative cable.
- Erase the DTC memory.
- Read the DTC.
Is DTC 3-5 indicated?
YES - Go to step 15.
NO - Short to ground in the floor wire harness; replace the floor wire harness.
- Disconnect the battery negative cable and wait for 3 minutes.
