- Erase the DTC memory (see page 23-38).
- Turn the ignition switch ON (II), and check that the SRS indicator light comes on for about 6 seconds and then goes off.
Does the SRS indicator light stay on?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures (see page 23-38).
- Turn the ignition switch OFF. Check the connections between the dashboard wire harness B 18P connector and the SRS unit, and between the engine compartment wire harness 2P connector and the right front sensor for 4-door model (see page 23-23) or 5-door model (see page 23-24).
Are the connections OK?
YES - Go to step 4.
NO - Poor contact at the SRS unit and/or right front sensor; reconnect or replace them. 
- Disconnect the battery negative cable and wait for 3 minutes.
- Disconnect the D1o connector from the D1i connector (A).
- Disconnect the P1o connector from the P1i connector (A).
- Disconnect the TL1o and TR1o connectors from the TL1i and TR1i connectors (A).
