Glue the fasteners (A) to the inside face of the rear window (B) as shown. Apply primer (3MN-200, or equivalent) to the inside face of the rear window as shown. If necessary, apply primer (3M N-200, or equivalent) to the areas where the window antenna terminal base (C) will be glued, then glue the base on: Be sure the fasteners (and window antenna terminal base cover) line up with the alignment marks (D). Be careful not to touch the rear window where adhesive will be applied. Hatched area: Apply primer here

Glue the upper moulding (A), side mouldings (B), and lower moulding (C) around the edge of the rear window (D): Glue the mouldings in the numbered sequence. After installing the mouldings, cut the corner edge areas (E) of the mouldings as shown. Be careful not to touch the rear window where adhesive will be applied.