Glue the fasteners (A) to the rear window opening flange (B) of the body. Fastener Locations A : Fastener, 4 Set the rear window in the opening, and centre it. Make alignment marks (A) across the rear window and body with a grease pencil at the 4 points shown. Be careful not to touch the rear window where adhesive will be applied. Remove the rear window.

With a sponge, apply a light coat of glass primer along the edge of the rear window (A) and moulding (B) as shown, then lightly wipe it off with gauze or cheesecloth: Do not apply body primer to the rear window, and do not get body and glass primer sponges mixed up. Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the rear window properly, causing a leak after the rear window is installed. Keep water, dust, and abrasive materials away from the primed surface. Hatched area: Apply glass primer here.