Special Tools Required Handle driver, 07749-0010000 Driver attachment, 52 x 55 mm, 07746-0010400 NOTE: Refer to the Exploded View as needed during this procedure. Test the alternator and regulator before you remove them (see page 4-28). Remove the alternator (see page 4-31). Remove the four through bolts. Heat the rear bearing seat with a 1,000 W hair drier for about 5 minutes (50 - 60oC, 129 - 140oF).

Separate the rear housing from the drive-end housing by inserting a flat tip screwdriver into the openings and prying them apart. NOTE: Be careful not to damage the stator with the tip of the screwdriver. Separate the rear housing (A) and drive-end housing (B) with the stator (C) attached to the rear housing.