NOTE: Put on gloves to protect your hands. Wear eye protection when removing the glass with piano wire. Use seat covers to avoid damaging the seat. Use glass adhesive set, P/N. 08C73-X0230N. Pull up the side trim (A) to release the clips (B) from the retainers (C), then remove the trim from each side of the windshield. Remove these items: Windshield wiper arms (see page 22-179 Cowl covers (see page 20-114)

Remove the moulding (A) from the upper edge of the windshield (B). If necessary, cut the moulding with a utility knife. If the old windshield is to be reinstalled, make alignment marks across the glass and body with a grease pencil. Pull down the front portion of the headliner (see page 20-68). Take care not to bend the headliner excessively, or you may crease or break it. Apply protective tape along the edge of the dashboard and body. Using an awl, make a hole through the rubber dam and adhesive from inside the vehicle at the corner portion of the windshield. Push a piece of piano wire through the hole, and wrap each end around a piece of wood.