If necessary, remove the bolts, then remove the grab handle bracket (A). Remove the remaining grab handle brackets, as needed. Fastener Locations : Bolt, 6 Install the headliner in the reverse order of removal, and note these items: When reinstalling the headliner through the door opening, be careful not to fold or bend it. Also, be careful not to scratch the body. If the threads on a visor and grab handle screws are worn out, use an oversized self-tapping ET screw made specifically for this application. Check that both sides of the headliner are securely attached to the trim.

SRS components are located in this area. Review the SRS component locations (see page 23-23), and the precautions and procedures (see page 23-25) in the SRS section before performing repairs or service. NOTE: Put on gloves to protect your hands. Take care not to damage, wrinkle or twist the carpet. Be careful not to damage the dashboard or other interior trim pieces. Remove these items: Front seats, both sides (see page 20-87) Rear seat cushion, folding type (see page 20-95), fixed type (see page 20-96) Rear seat side bolsters, both sides, folding type (see page 20-95) Kick panels, both sides (see page 20-64) Front door sill trim, both sides (see page 20-64) Seat side trim, both sides (see page 20-64) Centre console (see page 20-73) Driver's dashboard under cover (see page 20-76) Passenger's dashboard lower cover (see page 20-78) LHD: Remove the nut (A), and using a hex wrench, release the clip (B), then remove the footrest (C). Fastener Locations A : Nut, 1 B : Clip, 1